AA Polaris Xpedition Launch Control Module

Fits all 2024+ Polaris Xpedition 2 & 5 Seat Models Launch control for your Xpedition! This module utilizes a momentary switch to be engaged and allow for launch control to build boost(if you have our turbo) at the starting line for drag racing, or other types of racing.... and just plain fun. The amount of boost you build at the line depends on your CVT clutch engagement, and RPM settings in the launch control module. The higher the engagement RPM, the more boost you can build. To be honest, on the Xpedition models... this is mostly for fun and to create pop/bangs. This is mostly created for our turbo kit, but can also be used on any vehicle with our tune. We do suggest having an aftermarket exhaust like the AA Dual Suppressor LCM is programmed for 2000 RPM launch which is just right at or slightly above clutch engagement. Launch RPM is programmed by us, but can also be changed via Windows computer and DynoJet C3 software by the end user. Developed with DynoJet with our own wiring, switch, programming, and calibration For drag racing, launch control is best to have between 200-500 RPM above engagement point. This requires using more brake, and will load the motor/turbo for higher boost pressure. This is harder on the belt and clutches, but is okay for when used in moderation. For playing around/fun, using launch control is best used at your engagement RPM to prevent clutch/belt issues. To engage launch control, fire the vehicle up and make sure the vehicle is at an idle (module will not engage launch mode if vehicle is over 1500 RPM). Now press and hold the launch switch while giving the vehicle throttle. Go full throttle and the vehicle should hold at your desired launch RPM. Most will hold the brake at the same time to keep vehicle from creeping forward. When ready to accelerate, drop the brake and launch switch at the same time and the vehicle will..... well launch! Adjusting Launch RPM : For more information on this, go to our tech section and read our post on using/adjusting your LCM. Basic rundown is: Download the DynoJet C3 software (from dynojet.com/downloads), plug in your LCM via the supplied USB, then go to "Configure", “Feature Enables and Inputs Selections” then click “Launch Control” and you’ll see target RPM. Change this value as desired, click “Send” up top (green upward arrow), and that’s it. Part # : 117-96070018